 |
 |
 |
 |
 |
News
up to 2mm thick.
Klick here to watch
our video clip.
Machine
shown is the converted 300 Watt laser WiTEC with retooled milling
technology.
The
capacitive measuring head works without contact to the steel-upper-plate
In
addition to the complete integration there is the possibility of adding
a fifth axle to the four-axle machine if preferred.
A
steered turning apparatus with torque engine can also be added to the
machine at a later point
The
picture shows a turning apparatus, which can be used as both a C- andB- Axle. If the work area is needed for large 3-D work, then the apparatus
can easily be taken out of the machine manually.
© 2004 - 2009 Wissner LTD. Mechanical Engineering. All rights reserved.
August-Spindler-Straße
14 • D 37079
Göttingen • Phone
+ 49 (0) 5 51 / 5 05 08 - 14